Freshly installed high efficiency furnace and a residential gas water heater

Space Heater Safety: Outlets, Cords, and Circuits to Avoid This Winter

East Texas winters are usually mild, but a hard cold snap can roll through Tyler and Longview with little warning. When it does, a lot of homeowners pull a space heater out of the closet to warm up a chilly bedroom or home office. That’s fine, as long as you follow a few space heater safety basics.

Space heater safety starts with where the heater gets its power. The National Fire Protection Association reports that space heaters are involved in a large share of home heating fire deaths. Many of those risks come down to the outlet, the cord, or the circuit behind the wall. The licensed electricians at Evans Air Conditioning, Plumbing & Electrical explain what to avoid.

Why Space Heaters Are Hard on Your Electrical System

Most plug-in space heaters draw up to 1,500 watts. On a standard 120-volt outlet, that’s about 12.5 amps.

Most bedroom and living room outlets sit on a 15-amp circuit, and that circuit usually also feeds other outlets and lights. Electricians size circuits so a load that runs for hours stays at or below about 80% of the breaker rating, which is 12 amps on a 15-amp circuit. A single space heater can use nearly all of that on its own. Add a TV, a lamp, or a phone charger on the same circuit, and you’re asking a lot of the wiring.

Outlets to Avoid

Not every outlet in your home is a good match for a space heater. Skip any outlet that is:

  • Loose. If the plug wiggles or slides out easily, the contacts inside are worn. A weak connection heats up under a heavy load.
  • Warm, discolored, or scorched. These are signs of heat damage. Stop using that outlet and have it checked.
  • A two-prong outlet using an adapter. Older homes often have ungrounded outlets. A three-prong adapter doesn’t add a ground and isn’t meant for a heater.
  • Sharing a circuit with other heavy loads. Outlets near a microwave, hair dryer, or window unit may already be close to their limit.
  • In a bathroom or near water, unless the manufacturer says that model is designed for it.
  • Hidden behind curtains, bedding, or furniture. Heat can build up where you can’t see it.

If your home is short on safe, solid outlets, our team handles plug and switch installation to replace worn outlets or add new ones where you need them.

Cords to Avoid

The cord that came with your heater is the only cord it should use. Keep these rules in mind:

  • No extension cords or power strips. They aren’t built for the steady current a heater pulls and can overheat. Plug the heater directly into a wall outlet.
  • No damaged cords. Retire any heater with a frayed, cracked, or pinched cord.
  • Don’t run the cord under rugs or furniture. Covering a cord traps heat, and foot traffic can damage it over time.
  • Pay attention to a hot plug. A plug or cord that feels hot while the heater runs means something is wrong with the heater, the outlet, or both. Turn it off and call an electrician.

Circuits to Avoid

Even a good outlet can sit on an overloaded circuit. Watch for these situations:

  • Two heaters on one circuit. Two 1,500-watt heaters will overload a standard 15-amp circuit.
  • A circuit that already trips. If the breaker trips when the heater runs, the circuit is telling you it’s overloaded. Don’t keep resetting it.
  • Lights that dim when the heater kicks on. That can point to an overloaded circuit or a loose connection.

Not sure which outlets share a circuit? Your panel directory may tell you, but labels are often missing or out of date. An electrical safety inspection can map your circuits, check outlets and connections, and flag any wiring that needs attention. If you rely on a heater in the same room every winter, ask about a dedicated circuit.

A Quick Space Heater Safety Checklist

  • Keep the heater at least three feet from anything that can burn, including bedding, curtains, and furniture.
  • Choose a heater with tip-over and overheat shutoff.
  • Look for a label from a recognized testing lab, such as UL, ETL, or CSA.
  • Set it on a flat, hard floor, not on a rug, bed, or table.
  • Turn it off when you leave the room or go to sleep.
  • Keep kids and pets away from it.
  • Test your smoke alarms before cold weather arrives.

What About Gas or Kerosene Heaters?

Electric space heaters don’t produce carbon monoxide, but fuel-burning heaters can. If you use one, choose a model designed for indoor use, follow the manufacturer’s ventilation instructions, and make sure working CO alarms are installed near sleeping areas. Evans installs and replaces CO and smoke detectors throughout East Texas.

If You Need a Space Heater, Look at the Bigger Picture

A space heater is meant to supplement your heating system, not replace it. If one room never warms up or you lean on a heater every cold night, your furnace or heat pump may need attention. A heating repair visit or seasonal furnace maintenance can often fix the real problem. Our post on signs your furnace needs a tune-up covers what to watch for.

Stay Warm and Safe With Evans

The Original Evans Air has served East Texas since 1978. Our licensed electricians help homeowners in Tyler, Longview, Lindale, Whitehouse, Bullard, and Jacksonville find and fix the outlet and circuit problems that make winter heating risky.

Call (903) 993-4779 or request an appointment online. Ask about our Shield Membership for year-round maintenance and member perks.

Texas Electrical License #592546

Information about how to prep your home for cold weather from The Original Evans Air in Tyler, TX

Cold Weather Prep: Protecting Your Texas Home This Winter

Freezing temperatures can cause serious issues for your home in Tyler, Flint, Bullard, Lindale, and surrounding areas. From burst pipes to heating system failures, cold weather can create costly problems if your home isn’t properly prepared. Evans Air is here to help with expert advice on keeping your home safe, warm, and efficient during the winter months.


Prevent Frozen Pipes

Frozen pipes are one of the most common winter issues, but they’re also preventable. Here are some steps to protect your plumbing:

  • Insulate Pipes: Use foam insulation or heat tape to protect pipes in unheated areas, such as attics, basements, and crawl spaces.
  • Let Faucets Drip: Allowing a slow drip keeps water moving, reducing the risk of freezing.
  • Open Cabinet Doors: Let warm air circulate around pipes under sinks, especially those on exterior walls.
  • Seal Drafts: Use caulk or foam sealant to close gaps where cold air can enter and reach your pipes.
  • Know Your Shut-Off Valve: Locate and test your main water shut-off valve so you can act quickly in case of a burst pipe.

If you do encounter an issue with your plumbing system related to the extreme cold temperatures, call the experts at Evans Air right away for emergency plumbing services! Our teams are standing by to tackle any customer issues during winter cold snaps.


Ensure Your Heating System is Ready

Your heating system is critical to keeping your home comfortable and safe during freezing weather. Follow these tips to ensure it’s prepared:

  • Schedule a Furnace Tune-Up: Professional furnace maintenance from Evans Air can identify issues before they lead to a breakdown.
  • Replace Air Filters: Dirty filters can strain your system and reduce efficiency. Change them regularly for optimal performance.
  • Test Your Thermostat: Verify that your thermostat is working properly and set it to maintain a consistent indoor temperature.
  • Seal Leaks: Check for air leaks around windows, doors, and ductwork, and seal them to prevent heat loss.

Protect Outdoor Fixtures

Outdoor plumbing is especially vulnerable to freezing temperatures. Take these precautions:

  • Disconnect Garden Hoses: Remove and store hoses indoors to prevent freezing and cracking.
  • Drain Outdoor Faucets: Shut off the water supply to exterior faucets and drain any remaining water. Use insulated covers for added protection.
  • Winterize Sprinkler Systems: Follow the manufacturer’s instructions to properly drain and protect your irrigation system.

Stay Safe Indoors

Freezing weather can bring unexpected challenges. Here’s how to stay safe and comfortable inside your home:

  • Use Space Heaters Safely: Keep space heaters at least three feet away from flammable materials and never leave them unattended. Avoid plugging them into extension cords.
  • Test Smoke and Carbon Monoxide Detectors: Ensure these devices are functioning properly, especially if you’re using alternative heating methods like fireplaces.
  • Maintain Indoor Air Quality: Winter can lead to dry air. Consider using a humidifier and scheduling professional duct cleaning to improve airflow and comfort.
  • Keep Pets Warm: Bring pets indoors during freezing weather and provide them with warm bedding to ensure their safety and comfort.

Stay Weather Aware

Freezing conditions can develop quickly in East Texas. Stay informed by monitoring local weather forecasts and updates to ensure you’re prepared for sudden temperature drops.


Evans Air is Ready to Help

Whether you’re facing a burst pipe, a furnace malfunction, or another cold-weather emergency, Evans Air’s team of professionals is here to help. We offer reliable HVAC and plumbing services to keep your home safe and warm all winter long.


Contact Evans Air Today

Don’t wait until freezing temperatures cause a problem. Prepare your home now with help from Evans Air. Serving Tyler, Flint, Bullard, Lindale, and surrounding areas, we’re your trusted partner for heating and plumbing solutions. Call us at (903) 993-4779 or schedule an appointment online today!


With preparation and the expert support of Evans Air, you can protect your home and enjoy a safe, comfortable winter season.